The CAM compressed air flowmeters clamp onto a pipe, with two flow-sensing probes projecting into the pipe through 3/16-in. drilled holes. It seals directly to the pipe; no cutting or welding is required for installation. Because each flowmeter is made and calibrated for a specific size of pipe, the digital display indicates flow directly, with no setup or adjustment. The meter measures flow by maintaining one probe warmer than the other. It calculates the mass velocity from the amount of heat required, and then calculates the flow on the basis of pipe area. The flow rate, in scfm, is shown on a large, four-digit display; a 4-20 mA output and a pulse output permit remote display, totalizing and data collection.
CAM 5200
(5200)
1/2-1 1/2 inch line size compressed air flowmeters.
CAM 5400
(5400)
2-6 inch line size compressed air flowmeters.
CAM SRD
(5200-SRD)
Remote reading for CAM 5200 and 5400 compressed air flowmeters.
CAM 5200 Drill guides
(5200-DG)
The CAM series flowmeters need holes drilled into the pipe for installation. A drill guide is used to locate these holes.
CAM 5400 drill guides
(5400)
The CAM series flowmeters need holes drilled into the pipe for installation. A drill guide is used to locate these holes.
